Lay3rs TPM Wash Solvent
| SKU: | 320023 |
- Hoogwaardige service en support
- Eenvoudige mogelijkheid voor leasen.
- Gunstige verzendvoorwaarden en retourbeleid
- Fysieke showrooms op diverse locaties in Nederland
- Op werkdagen voor 14:00 besteld, morgen in huis
- Klantenservice van 10:00 tot 17:00
Tripropylene glycol monomethyl ether (TPM) is a non-flammable*, low odor solvent that can be used to clean and dissolve uncured resin on stereolithography (SLA) 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before needing to be replaced.
TPM is not currently certified for use with Formlabs biocompatible resins.
Formlabs generally recommends using isopropyl alcohol (IPA) with a concentration of at least 90% to wash parts. If you are unable to use IPA, TPM is a tested alternative.
TPM is compatible with the Formlabs Finish Kit, Form Wash, and Form Cure.
For a detailed workflow, visit support.formlabs.com/.
*This product is not labeled as dangerous according to Regulation (EC) No. 1272/2008.
Help ons en andere klanten door het schrijven van een review